Hold a screwdriver at the extreme end of the handle with the blade down, move the blade to within 3/4 inch (19.05 mm) of the magnets. Check the flywheel magnets for the proper strength using this rough test. Check the air gap between the flywheel magnets and the laminations of an externally mounted coil or module. NOTE: STANDARD POINT IGNITION MAY HAVE TO BE DISCONNECTED AT THE IGNITION SHUTOFF (AT THE SPEED CONTROL).Ĥ. If spark occurs, check the ignition switch, safety interlock switches, electrical wiring for shorting to ground, or oil shutdown switch. Reinstall the blower housing and crank the engine over. Remove the blower housing, disconnect the ignition ground lead at the ignition coil (solid state only). Check for the correct spark plug and for cracks in the porcelain, pitted or burned electrodes, excessive carbon buildup, and proper air gap setting. Check for spark using a commercially available spark tester and following the tester's recommended procedure.Ģ. Juan Hernandez, here is the testing procedure for the ignition of your Tecumseh:"ġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |